Also known as escutcheon pins, these nails have a domed head that sits above the surface.

For better surface holding, the head is approximately 75% larger than a standard nail head.

Also known as scaffold and duplex nails, drive these nails in up to the first head and the second head remains exposed for easy removal.

The small, easy-to-conceal head sits flush with the surface for a smooth, finished appearance.

The flat head sits flush with the surface for a smooth, finished appearance.

Also known as spikes, these nails have a larger diameter and longer shank than standard nails.

These nails have the smallest shank and head sizes of our nails for nailers.

Also known as round-head Type U drive screws.

The wide, flat head holds fabrics in place.

These steel spikes are manufactured according to AREA (American Railroad Engineering Association) specifications.

Join soft and hard woods.

These anchors are also known as drive rivets. To install, hammer the pin into the body. Pry out the pin to remove.

Also known as drive rivets, install by hammering the screw into the body. Unthread the screw to remove.

A tamper-resistant nut prevents unwanted removal of the object you are anchoring.

A zinc plating provides corrosion resistance in wet environments.

These 18-8 stainless steel anchors have good chemical resistance.

Keep fixtures solidly in place—these anchors have two locking wedges that won't shake loose.

These 18-8 stainless steel anchors have good chemical resistance.

An open-end cap nut provides a finished appearance.

Also known as mungo anchors, these have large fins that prevent rotation.

Also known as lag shields, these anchors are designed for use with large-diameter wood screws.

These 18-8 stainless steel anchors have good chemical resistance.

Install like a stud anchor—just thread the anchor, a nut, and a washer onto the end of a threaded rod, drive into a hole, and turn the nut to expand the base. Also known as rod anchors, they're often used with threaded rod to hang pipe and wiring.

A zinc plating provides corrosion resistance in wet environments.

Often referred to as four-way expansion anchors, these expand in four directions to resist loosening from vibration.

Bolts are beveled under the head for a flush finish in countersunk holes.

These steel anchors are available with corrosion-resistant finishes.

These steel anchors are available with corrosion-resistant finishes.

For narrow holes and small cavities where toggle anchors won't fit.

Used with adhesive in bricks and hollow blocks, such as cinder blocks, these mesh tubes create a stronger hold for rods and studs than other anchors.

A spring-loaded toggle holds against the back of the material.

A shallow head makes these bolts good for low-clearance applications.

These anchors fit a range of sheet metal and wood screw sizes since they form their own threads when installed.

Easy to install, tap these anchors in like a nail—no drilled hole required.

A drilled hole is required for installation.

A wing-like toggle holds against the back of the material and spreads the force over a large area to hold 30 lbs. or more.

Secure multiple cable bundles with a single holder.