Also known as pigtail holders. Temporarily wire these sockets to provide light during construction.

Lenses disperse light to reduce glare, while protecting bulbs from damage.

Attach mini and full-size flashlights to a hard hat and keep your hands free to work.

Free your hands for other work by mounting a flashlight to a nearby surface.

Turn your mini flashlight into an illuminated magnifying glass.

Turn a mini flashlight into a headlamp with these straps.

Block the transmission of ultraviolet light.

Block out stray and unwanted light.

Hardwire these sockets to a power source.

Lock bulbs in place to prevent vibration from shaking them loose.

Use these extenders when bulbs are too short to fit into deep or recessed fixtures.

Fasten lamp pipe to a socket or base.

Stop vibration from shaking tubular fluorescent and LED bulbs loose.

A sealing gasket keeps out oil and other contaminants.

These filters fit over miniature light bulbs with a bulb diameter up to 7/16".

A solid lens retains glass if a screw-in bulb breaks.

Replace hard-to-grip miniature bulbs in equipment such as control panels and indicators. Install new bulbs without leaving behind oil from your fingers that can cause bulbs to burn out.

These changers create a vacuum seal against a light bulb. They're often used to change bulbs in recessed lights where there's no room to reach around the bulb.

Often used in large, open workspaces, these switches can be wired on opposite ends of the room to control lights on the same circuit. They're also known as three-way and four-way switches.

Install these switches inline on a lamp cord.

Also known as three-way switches, these are often used in large, open workspaces and can be wired on opposite ends of the room to control lights on the same circuit.

Also known as three-way switches, these are often used in large, open workspaces and can be wired on opposite ends of the room to control lights on the same circuit.

Designed to work with landscape and security lighting.

Switches fit single device (1 gang) outlet boxes.

Control equipment with high currents, such as landscape lighting, pumps, and heaters.

Rated NEMA 3R, these rain-tight switches protect against falling liquids and light splashing.

Install these switches in a panel cutout.

Control two devices and delay the shut off of one device by up to one hour. These switches are often used with lights and fans for ventilation.

Push and release the button to activate—no electricity required.

Automatically turn electrical equipment on or off after a set interval.

In addition to being more energy-efficient than magnetic ballasts, these are lighter and quieter.

These ballasts are often found in older installations.

Pair these starters with pulse-start ballasts.

Safely dispose of used light bulbs by recycling them. Containers include a paid shipping label to send the bulbs to a recycling facility.